PPE rooms should protect clean kit, yet many accumulate dust quickly. The causes are usually airflow, open storage, and weak housekeeping patterns. Tackle these and the problem shrinks fast.

Typical root causes

• Air drawn through the room on the way to extract points, pulling dust with it.
• Open racking and uncovered bins that catch fallout.
• Footfall from dusty areas, plus donning and doffing that releases fibres and particles.

Control the air

• Position the room away from extraction draws; keep doors normally closed and fit a simple lobby if needed.
• Use an air scrubber for recirculating filtration to cut background particulate; check airflow under load and maintain filters.
• Aim for slight cleanliness bias: keep the storage area neutral to gently positive relative to dusty zones so air leaks outward, not in.

Storage that resists deposition

• Prefer closed cupboards and lidded containers for infrequently used items.
• Raise shelves from the floor and leave clearance above for easy cleaning.
• Label “clean stock only” sections and keep returns quarantined until inspected.

Housekeeping that sticks

• Vacuum high ledges, tops of lockers, and door frames using long-reach tools; accessories like MAXVAC EasyReach help access without ladders.
• Use MAXVAC Supra vacuums or equivalent high-efficiency units; never sweep or blow.
• Set a short, frequent schedule over occasional deep cleans; log checks at the door.

Practical takeaways

• Control airflow and keep doors shut; place the room off dust pathways.
• Close storage, raise shelves, and separate clean stock from returns.
• Vacuum, don’t sweep—include the high, forgotten surfaces.
• Maintain filters and verify performance during use.

Small layout changes and disciplined cleaning turn PPE stores from dust sinks into reliable sources of clean kit.